Targa Miata
MIATA BUILD
This is the last entry
August 18, 2011 - Not all the work on the Targa car is big cool projects like skid plates.
It's also getting some maintenance. For one, I'm changing out the front hubs to make sure they're at full strength. The current hubs had a total of about 10,000 miles on them but a large proportion of that was with hot race rubber bolted on. And, just like the original build, I had to grind off 75% of the teeth on the ABS trigger wheel in order to drop the number of pulses per mile to a reasonable number. The ABS sensor is used to trigger my Coralba rally computer, and it can only deal with 16,000 pulses per mile or so. With the modified ABS wheels, I get about 9,900.
And then I found a problem. The replacement hubs have an ABS ring that's about 2 mm smaller in diameter than the stock part. This meant the air gap to the non-adjustable pickup was too big, and it wasn't triggering the rally computer. That's not good. Luckily, the rings are just pressed on so I pulled off the old stock one and put it on the new hub. If only I'd noticed that before I spent all that time grinding!
tags: hubs, wiring, computer